Alfa Laval - Remise en service de PureBallast

Remise en service de PureBallast

Si votre système Alfa Laval Pureballast est inactif depuis 12 mois ou plus, il se peut qu’il ne fonctionne plus comme prévu. Dans le pire des cas, il peut avoir développé des défauts qui peuvent conduire à des dommages au démarrage. La remise en service est recommandée pour prévenir les incidents coûteux et assurer le rendement conformément à l’approbation de type.

What we do

Recommissioning begins with a status check of your PureBallast system. This determines the scope and timing of the recommissioning work, so that we can prepare in advance and have any necessary parts on hand. Based on the results of the status check, we perform any needed corrections, adjustments, updates or optimizing software upgrades. Afterwards, even if no faults were found, we perform a full system test to verify your system’s performance. In addition, we provide operator training while on board to ensure that your crew is ready to use the system.

En quoi pouvons-nous vous aider ?

N'hésitez pas à nous contacter pour toute question ou demande de service.

Contactez-nous

Pour un service d'urgence marine, composez le +46 4636 7700.

Benefits

  • You avoid potentially costly damage at start-up
  • You know that your equipment is working reliably
  • You know your system will perform according to type approval
  • You reduce operating and maintenance costs
  • You reduce operating and maintenance costs

Scope of service

Status check

A check of your PureBallast system is done well ahead of the main work to allow preparation time and the acquisition of any necessary parts. The check includes:

  • Visual inspections
  • Alarm evaluation
  • Ballasting cycle evaluation
  • Deballasting cycle evaluation

The results of the status check determine the scope and timing of the main recommissioning work.

 

Recommissioning work

  • Based on the results of the status check, we perform the following as needed:
  • Function tests and adjustments of alarms, pneumatics, valves, filter and control
  • Function tests and adjustments of the ballasting cycle and deballasting cycle
  • Software upgrades
  • Cleaning-In-Place (CIP)

System test

Following the recommissioning work, we perform a full system test to verify the performance of your PureBallast system. This includes operational testing of:

  • Ballasting cycle
  • Deballasting cycle
  • Remote interface, if applicable

The comprehensive system test is documented in a signed Recommissioning Test Form.

 

Operator training

While on board, we provide operator training to ensure that the crew is ready to use the PureBallast system.

Other 360° Service Portfolio services for your equipment

  • Calibration for PureBallast
  • Performance Audit for PureBallast
  • Installation Supervision for PureBallast
  • Condition Audit for PureBallast